And after that? Dead?
Yes ,
no reply ,
once got till Uboot version only . after that no response
Hi
please suggest further if this board can be revived or not ?
Is there nay way to get this working ?
All ,
This board seems as hardware broken . Nothing proceeding to boot up
This looks like a RAM problem. The first stage sets up the RAM chip. Then the second stage is loaded into RAM and executed.
With direct from China deals you will get a few units DOA. If you can't warranty it you could try as a last ditch attempt reflowing the solder on the SoC and RAM.
Hi mk ,
Thanks For Reply. Now i tried again , i was playing wtih baord and just pressed the heatsink of main chip . then it connected on 192.168.1.1 . It worked 2-3 times while pressing on the heat sink .
===================================================================
MT7621 stage1 code done
CPU=500000000 HZ BUS=166666666 HZ
===================================================================
U-Boot 1.1.3 (Apr 11 2015 - 20:07:37)
SoC:MediaTek MT7621
DRAM: 512MB(448MB LowMem,64MB HighMem)
relocate_code Pointer at: 8c0a8000
Please sugget fruther .
Hi,
One question as it was giving me all code on terminal after pressing on the heatsink of MT7621. is this Chip working or not ? do i need to solder this again or only RAM ?
The one you press on is most likely the problem. Outside the scope of this forum, you need to look at ways to "reflow the solder." I would use a heat gun. Another approach is to put the whole board into an oven.
Thanks ! Searching service near by me .