Hi,
I already installed 24.10.2 in the past as described here. Today, I tried to upgrade to latest 24.10.5 openwrt-24.10.5-qualcommax-ipq807x-xiaomi_ax3600-squashfs-sysupgrade, but the process failed.
The router led, after switching it on, starts blinking orange, than fixed orange and finally fixed blue for some seconds and it reboots (it seems a boot-loop). The LAN led are switched off.
I tried the unbrick procedure, but it did not work. What could it be the problem?
Thank you
Can you show error messsages produced?
Unfortunately, there is not any error message.
sudo dnsmasq --no-daemon --listen-address=192.168.31.100 --bind-interfaces --dhcp-range=192.168.31.2,192.168.31.2 --enable-tftp --tftp-root=/tmp/tftp
dnsmasq: started, version 2.90 cachesize 150
dnsmasq: compile time options: IPv6 GNU-getopt DBus no-UBus i18n IDN2 DHCP DHCPv6 no-Lua TFTP conntrack ipset nftset auth cryptohash DNSSEC loop-detect inotify dumpfile
dnsmasq-dhcp: DHCP, IP range 192.168.31.2 -- 192.168.31.2, lease time 1h
dnsmasq-tftp: TFTP root is /tmp/tftp
dnsmasq: reading /etc/resolv.conf
dnsmasq: using nameserver 127.0.0.53#53
dnsmasq: read /etc/hosts - 8 names
I am using ubuntu 22.04. My /etc/hosts
You dont have to redo 1st time install, just use sysupgrade or even better owut or luci-app-attendedsysupgrade.
Right, as I wrote in the first post, I installed the sysupgrade, but now I have a problem with the router that is not reachable both via command line and gui. So I tried the recovery procedure that does not work as well.
Likely roaming or dnssec customisations....
Show the sysupgrade command session log you did....
The router enters a continuous boot loop. If I try to reset it, I can access it, but if I restore the previously saved configuration, the boot loop starts again. I can't even manually configure the wifi from scratch because it reboots itself after a few settings. So I'll wait for the next 25.12 update; I think this version has some issues.
OK, unzip the config on the desktop and type back config over luci?