XD3200 LEDE install with uboot and reset button

Hello,

Could you please tell if the following LEDE firmware will work if I install it via tftp by just pressing the reset button? Is the layout sufficient?

https://downloads.lede-project.org/releases/17.01.2/targets/ar71xx/generic/lede-17.01.2-ar71xx-generic-xd3200-squashfs-sysupgrade.bin

Thank you!

Here is the output of the u-boot.

U-Boot 1.1.4 (Sep 25 2016 - 12:59:29)

ap152 - Dragonfly 1.0DRAM:  
sri
ath_ddr_initial_config(278): (ddr2 init)
ath_sys_frequency: cpu 775 ddr 650 ahb 258
Tap values = (0x10, 0x10, 0x10, 0x10)
128 MB
Top of RAM usable for U-Boot at: 88000000
Reserving 200k for U-Boot at: 87fcc000
Reserving 192k for malloc() at: 87f9c000
Reserving 44 Bytes for Board Info at: 87f9bfd4
Reserving 36 Bytes for Global Data at: 87f9bfb0
Reserving 128k for boot params() at: 87f7bfb0
Stack Pointer at: 87f7bf98
Now running in RAM - U-Boot at: 87fcc000
Flash Manuf Id 0xef, DeviceId0 0x40, DeviceId1 0x18
flash size 16MB, sector count = 256
Flash: 16 MB
In:    serial
Out:   serial
Err:   serial
Net:   ath_gmac_enet_initialize...
No valid address in Flash. Using fixed address
ath_gmac_enet_initialize: reset mask:c02200 
athr_mgmt_init ::done
Dragonfly  ----> S17 PHY *
athrs17_reg_init: complete
SGMII in forced mode
athr_gmac_sgmii_setup SGMII done
: cfg1 0x80000000 cfg2 0x7114
eth0: 00:03:7f:09:0b:ad
eth0 up
eth0
Setting 0x181162c0 to 0x48902100
Warning: reset button has been pushed!!!!!!
checking the reset button cmd in firmware
download firmware: tftp 0x80060000 upgrade.bin 
Trying eth0
eth0 link down
FAIL
Using eth0 device
TFTP from server 192.168.0.141; our IP address is 192.168.0.144
Filename 'upgrade.bin'.
Load address: 0x80060000
Loading: *Tx Timed out
T Tx Timed out