WRT32x Boot problem

[GTL]

Hi. I have two Linksys WRT32x
I deleted the memories in the router:
**Forth, open PuTTY and SSH into router **
**The commands you will need to enter: **
erase nvram
I'm not able to execute commands.

Can somebody help me?
I use a cable PL230HX TTL USB
Linux, u boot re-writing results:
https://www105.zippyshare.com/v/tybWrnfK/file.html
end result unchanged:
Youtube video

[anomeome]

Please try something like either:

cat $1 | curl -F 'f:1=<-' ix.io
cat $1 | nc termbin.com 9999

and paste the link, rather than the screen capture or the commercial drop.

Not sure what lead you to the erase nvram but it looks that your uboot is intack; can you just do a help at the CLI. If so you should be able to just tftp an image as outlined on the wrtpac page.

[Ansuel]

Fun fact is that nvram erase normally removes also uboot so....

[lleachii]

@GTL, welcome tot the community!

@GTL

I deleted the memories in the router:
**Forth, open PuTTY and SSH into router **
**The commands you will need to enter: **
erase nvram

• Why did you do this?
• What was your goal?
• What instructions or Wiki told you to do so?
• Have you seen this: https://openwrt.org/toh/linksys/linksys_wrt32x#debricking
• Did you see this: https://openwrt.org/toh/linksys/linksys_wrt32x#installation

That command also erased your backup recovery partition...