I've configured the WNDR3700v1 as a switch and setup a trunk port on one of the lan ports. That configuration was successfull as I was able to obtain IP's on all three vlans that were on the trunk port
Unfortunately I'm having issues trying to use the WAN port as a trunk port. I've read that I would get better performance if I use one of the lan ports as a trunk port but I would like to figure this out.
I'm including a picture of my config below. I know setting the wan port as a trunk port is possible as I have read references to it in the forum but I wasn't able to get it working.
Any assistance would be greatly appreciated.