Question for WLAN Settings (here Meraki MR18, but I think it’s nearly the same with other Hardware)
When I look at the Hardware capabilities and I try to understand it, there are three physical sender/receiver phy0…phy2. with different power (see below). In other postings I understand that one Wiphy could be for detection of other signals and so on to optimize operation. (Usage of phy0 and phy1 is clear for me, I hope)
In the capabilities all Wiphy’s support same modes. By virtue of power output I think phy2 is for such things. But I have no idea how to config this Wiphy phy2 so that it could work for radar detection and so on.
My first idea was to config two phy2 networks (Band1 & Band2) with mode=monitor. But when I did so, nothing else changed… Is there anybody that could tell me how to config phy2?
Summery of HW capabilities
Wiphy phy2 Band 1 11dBM and Band 2 8bdBm
Wiphy phy1 Band 2 16-23dBm
Wiphy phy0 Band 1 20dBm
{Band 1 (2,4Ghz), Band 2 (5GHz) }