Wavlink ws-wn572hp3 update

Installing and Using OpenWrt
1

hi all,
sorry for my englisch, i found no information about the ws-wn572hp3

here my solution :

go in recovery mode: press reset and power on and hold reset for 6-9 seconds
after this go to recovery interface 192.168.10.1 or 192.168.31.1 and flash the

wavlink_ws-wn572hp3-4g-initramfs-kernel.bin

after flash the kernel image go to openwrt 192.168.1.1 interface
and flash the full image
openwrt-23.05.1-ramips-mt7621-wavlink_ws-wn572hp3-4g-squashfs-sysupgrade.bin
to the device

after this you have a full openwrt on the router.

now you can manage the wan and lan interface, dont use the option noscan, because on noscan 1 the wan interface make 100mbit, on noscan 0 the wan interface make 1000mbit

i hope i can help.
br and have fun

2

Specifications;

  • Soc: MT7621DAT
  • RAM: 128MiB
  • Flash: NOR 16MiB GD-25Q128ESIG3
  • Wi-Fi:
    • MT7613BEN: 5GHz
    • MT7603EN: 2.4GHz
  • Ethernet: 2x 1GbE
  • USB: None - only used internally
  • LTE Modem: Quectel EC200T-EU
  • UART: 115200 baud
  • LEDs:
    • 7 blue at the front
      • 1 Power
      • 2 LAN / WAN
      • 1 Status
  • Buttons: 1 reset button

Installation:

  • press and hold the reset button while powering on the device
  • keep it pressed for ten seconds
  • connect to 192.168.10.1 via webbrowser (chromium/chrome works, at
    least Firefox 106.0.3 does not)
  • upload the sysupgrade image, confirm the checksum, wait 2 minutes
    until the device reboots

Revert to stock firmware:

  • same as installation but use the recovery image for WL-WN572HP3
3

I guess you found https://git.openwrt.org/?p=openwrt/openwrt.git;a=commit;h=dce66899bf243d78689afcc693340b891bbf4c2d, after all ?

4

This topic was automatically closed 10 days after the last reply. New replies are no longer allowed.