OpenWrt 22.03.5
wpad full
usteer
Im trying to setup roaming beetwin 2 AP R K V protocols are enabled
i need to make it kick whenever siganl is lower than -45dB no balancing beetwin APs (or 95% no less)
This instruction describs all the parameters
but i still dont know how to
https://openwrt.org/docs/guide-user/network/wifi/usteer
config usteer
# The network interface for inter-AP communication
option 'network' 'lan'
# Log messages to syslog (0/1)
option 'syslog' '1'
# Disable network communication (0/1)
option local_mode '0'
# Use IPv6 for remote exchange
option 'ipv6' '0'
# Minimum level of logged messages
# 0 = fatal
# 1 = info
# 2 = verbose
# 3 = some debug messages
# 4 = network packet information
# 5 = all debug messages
option 'debug_level' '5'
# Maximum number of neighbor reports set for a node
option max_neighbor_reports 6
# Maximum amount of time (ms) a station may be blocked due to policy decisions
option sta_block_timeout 30000
# Maximum amount of time (ms) a local unconnected station is tracked
option local_sta_timeout 120000
# Maximum amount of time (ms) a measurement report is stored
option measurement_report_timeout 1200000
# Local station information update interval (ms)
option local_sta_update 1000
# Maximum number of consecutive times a station may be blocked by policy
#option max_retry_band 5
# Maximum idle time of a station entry (ms) to be considered for policy decisions
#option seen_policy_timeout 30000
# Minimum number of stations delta between APs before load balancing policy is active
option load_balancing_threshold 0
# Minimum number of stations delta between bands before band steering policy is active
#option band_steering_threshold 5
# Interval (ms) between sending state updates to other APs
#option remote_update_interval 1000
# Number of remote update intervals after which a remote-node is deleted
#option remote_node_timeout 10
# Allow rejecting assoc requests for steering purposes (0/1)
#option assoc_steering 0
# Allow ignoring probe requests for steering purposes (0/1)
#option probe_steering 0
# Minimum signal-to-noise ratio or signal level (dBm) to allow connections
#option min_connect_snr 0
# Minimum signal-to-noise ratio or signal level (dBm) to remain connected
#option min_snr 0
# Timeout after which a station with snr < min_snr will be kicked
#option min_snr_kick_delay 5000
# Timeout (ms) for which a client will not be steered after rejecting a BSS-transition-request
#option steer_reject_timeout 60000
# Timeout (in ms) after which a association following a disassociation is not seen
# as a roam
#option roam_process_timeout 5000
# Minimum signal-to-noise ratio or signal level (dBm) before attempting to trigger
# client scans for roaming
#option roam_scan_snr 0
# Maximum number of client roaming scan trigger attempts
option roam_scan_tries 3
# Retry scanning when roam_scan_tries is exceeded after this timeout (in ms)
# In case this option is set to 0, the client is kicked instead
#option roam_scan_timeout 0
# Minimum time (ms) between client roaming scan trigger attempts
#option roam_scan_interval 10000
# Minimum signal-to-noise ratio or signal level (dBm) before attempting to trigger
# forced client roaming
#option roam_trigger_snr 0
# Minimum time (ms) between client roaming trigger attempts
option roam_trigger_interval 600
# Timeout (ms) for client roam requests. usteer will kick the client after this times out.
option roam_kick_delay 500
# Minimum signal strength difference until AP steering policy is active
#option signal_diff_threshold 0
# Initial delay (ms) before responding to probe requests (to allow other APs to see packets as well)
#option initial_connect_delay 0
# Enable kicking client on excessive channel load (0/1)
#option load_kick_enabled 0
# Minimum channel load (%) before kicking clients
option load_kick_threshold 95
# Minimum amount of time (ms) that channel load is above threshold before starting to kick clients
option load_kick_delay 1000
# Minimum number of connected clients before kicking based on channel load
option load_kick_min_clients 10
# Reason code on client kick based on channel load (WLAN_REASON_DISASSOC_AP_BUSY)
#option load_kick_reason_code 5
# Attempting to steer clients to a higher frequency-band every n ms.
# A value of 0 disabled band-steering.
#option band_steering_interval 120000
# Minimal SNR or absolute signal a device has to maintain over band_steering_interval to be
# steered to a higher frequency band
option band_steering_min_snr -45
# Interval (ms) the device is sent a link-measurement request to help assess
# the bi-directional link quality. Setting the interval to 0 disables link-measurements.
#option link_measurement_interval 30000
# Script to run after bringing up a node
#option node_up_script ''
# Message types to include in log
# Available types:
# - probe_req_accept
# - probe_req_deny
# - auth_req_accept
# - auth_req_deny
# - assoc_req_accept
# - assoc_req_deny
# - load_kick_trigger
# - load_kick_reset
# - load_kick_min_clients
# - load_kick_no_client
# - load_kick_client
# - signal_kick
#list event_log_types ''
# List of SSIDs to enable steering on
#list ssid_list ''
i didnt find any working config for roaming
some says use DAWN this one for stearing beetwind bands but other says usteer can do the same