Using 5/10 Mhz channels with IPQ-4019 with ath10k

[urielka]

Tried this with the following patches:

1. https://github.com/aredn/aredn/blob/main/patches/742-5-and-10mhz-ath10k-ct-support.patch
2. https://github.com/aredn/aredn/blob/main/patches/701-extended-spectrum.patch
3. https://github.com/aredn/aredn/blob/main/patches/744-dd-wrt-firmware.patch

Then i tried the following firmware packages:
ath10k-firmware-ct
ath10k-firmware-ct-full-htt

And lastly the latest from dd-wrt:
https://svn.dd-wrt.com/browser/src/router/mac80211/ath10k-firmware-38eeda3ae6f90fde5546bdd48ee4ff3090f238c0/ath10k/QCA4019/hw1.0/firmware-5.bin

All of them looks the same, chanbw is available but setting it to 10 doesn't do anything, it still works as a 20mhz (or 80mhz if it is set in the UI).

I am using:
8Devices Habanero with IPQ4019
OpenWRT 23.0.5.2 with kernel 5.15

@BrainSlayer can you please help here? In the previous post:

Enable Support for 5/10 MHz channel width on ath10K based wifi

@BrainSlayer Have you tested it with the DD-WRT firmware and the QCA9888. Someone tested for me with a QCA4019 and that seems to work but with the same patch the QCA9888 seems to stop working if I set it to 5 or 10MHz. At one point it seemed to work for a short time then stops transmitting.

It was mentioned that IPQ4019 works