USB3 not recognized

I have p&w619ac with snapshot firmware. I have install many pagkages for usb2 or usb3 but my router not recognite usb3. My usb is usb3 kington 32gb. If i use usb2 or harddisk it works.
Please help me! Thanks all

my router can not known my usb
i have install some driver for usb

kmod-usb-core - 5.4.162-1
kmod-usb-dwc3 - 5.4.162-1
kmod-usb-dwc3-qcom - 5.4.162-1
kmod-usb-printer - 5.4.162-1
kmod-usb-storage - 5.4.162-1
kmod-usb-storage-extras - 5.4.162-1
kmod-usb-storage-uas - 5.4.162-1
kmod-usb-xhci-hcd - 5.4.162-1
kmod-usb3 - 5.4.162-1
kmod-fs-btrfs - 5.4.162-1
kmod-fs-cifs - 5.4.162-1
kmod-fs-exfat0 - 5.4.162+5.14.1-1
kmod-fs-exportfs - 5.4.162-1
kmod-fs-ext4 - 5.4.162-1
kmod-fs-nfs - 5.4.162-1
kmod-fs-nfs-common - 5.4.162-1
kmod-fs-nfs-common-rpcsec - 5.4.162-1
kmod-fs-nfs-v4 - 5.4.162-1
kmod-fs-nfsd - 5.4.162-1
kmod-fs-vfat - 5.4.162-1

Unplug the USB3 drive then plug it back in. Check what was added to the system log after it was plugged in.

Nothing happen when i put in usb with usb3 flash. It works with usb2(in logread).

When i unplug and plug usb2 it worked


When I put usb3 no answer at all

are you sure the port is working ?

no, because it works with USB2. maybe my Router do not have enough driver for USB3.
My router is R&W619 ac 128MB.

Make sure the drive works in USB3 mode. Test the router with another drive.

USB3 has separate hardware and software paths than USB2. The 4 extra pins in a USB3 plug are used only for USB3.

When the ipq4019 was a new chip 5 years ago, special USB drivers had to be written for it, but I think they are fully integrated into usb3 now.

1 Like

I have already change some usb3 flashs and read logread and nothing happen.