I need some help from you guys. My Sitecom WLR-5100 v1 002 is bricked (after a factory firmware upgrade), but i can communicate to him by serial port (U-boot).
Baud Rate: 115200
Data Bits: 8
Parity : No
Stop Bits: 1
I want to flash the router with the factory firmware,
but the factory firm is a .dlf file and after studying the next topic:
Could you please post some pictures of the PCB and maybe the log of the bootloader?
I can't find any information about the WLR-5100 online and I'm curious which chipset's it uses.
Do you want to keep using the factory firmware or will OpenWRT (if possible) also fit your needs?
From your bootloader I read WLR-5100v1003 firmware loaded on v1002 hardware.
I have the WLR-4100v1002 having the very same PCB, but without the 5GHz. module soldered on it.
We may have the same SW since I read in mine: bootfile=uImageWLR-5100v1002
I suppose the factory SW is similar among other routers, therefore the WLR-8100 Factory firmware firmware recovery: https://openwrt.org/toh/sitecom/wlr-8100
may works for WLR-5100 as well
Edit: Why are you kicking a 2 year old topic back to life @Sirpolex? I could drink an additional beer instead of spending my time decrypting a firmware file for a question asked 2 years ago lol.
Before proceeding with the burning of Flash memory of my WLR-4100 I would like to know a revert procedure. I found this post and I preferred to resurrect it instead of a new one.
Thank you for your reply.
I try to execute the firmware without contaminating the Flash.
Nevertheless, I understood that we have several Flash Area containing Router specific piece of information like MAC addresses and clibration parameters. Like in the WLR-2100: