does anyone has backed-up this two files, and kindly share? during openwrt installation i was not able to save them and i can t go back to stock firmware. thanks in advance
Sure, but they are provider-branded and need to match your modem firmware. So what's your device version and modem firmware version?
ciao Andy, as far as I undestand these are my router specs. The seller told me it's operator unlocked, and ready to use with others operators. Except the disconneting issue it's actually working with spusu (italian operator), but original firmware is 3 austria. so stock firmware should be 3 austria.
zte_mf287 3_neo_austria
(CR_H3GATMF287V1.0.0B17)
the ATI command returns following value:
Revision: BD_H3GATMF287MODULEV1.0.0B13
SoC IPQ4018
CPU MHz 700
CPU Cores 4
Flash MB 128NAND
RAM MB 256
Modem IPQ4018 802.11a/b/g/n/ac
Do I need to double check with any terminal command? If yes, wich one?
thanks a lot
So I checked on mine and I was connected for over 25 minutes. My modem has BD_H3GATMF287MODULEV1.0.0B16, so it's a bit newer than yours. I'm pretty sure that you will be able to restore my backup, but I don't know if it's then possible to update the modem firmware since it doesn't match what mine expects. I can send you the files nevertheless.
Are you 100% sure that you don't have a weak power supply? Mine is rated 12V 1.5A.
thanks fot the file. I really appreciate your help! My power adapter is 12V 2A. I'll try to update the firmware. Thanks!!!
original sofware restored. thanks!!!
1 Like
This topic was automatically closed 10 days after the last reply. New replies are no longer allowed.