Hi everybody,
I have Cisco DPC3825 which has Serial (Tx Rx Gnd) pins on the board.
I have access to it via my prolific adapter and putty(Serial mode).
How can I transfer OpenWRT via serial port?
Thank you.
This device is not supported by openwrt. So the answer is that you can’t.
But this page mentioned that it supports!
Where? I see a tag at the bottom of the page that says unsupported.
Have you found an openwrt image for this device?
As mentioned on the top of your page DPC3825 is the same as EPC3825.
Cisco DPC3825/EPC3825
There is epc3825-flash_backup.bin.tar.gz at the bottom of the page that should be applicable by DPC3825.
That is a backup of the existing flash memory. That is not openwrt.
And on this, also unsupported
1 Like
This topic was automatically closed 10 days after the last reply. New replies are no longer allowed.