Not sure if I should post this here or in the "Installing and Using OpenWRT" section.
I have two EAP245v3 access points that I just installed 24.10.0 on. The install and setup went fine. My issue is that I have asymmetrical wifi transfer speeds on both access points.
Using iperf3, the upload speed from my laptop to the access point is consistently 300 Mbps (5 GHz, 40MHz channel width) but download from the access point to my laptop caps at 100Mbps. It's the same for both access points.
If I limit the Tx power on the EAP245 to 18db, my download speeds increase to 240Mbps.
Has anyone else seen this or figured out a fix? I also have two Unifi AP AC LR access points that are similar hardware and don't exhibit this behaviour.
Thanks