Hi there,
I have OpenWRT version 19.01 running on my TP-Link c7 v2 router. The network adapters are from Atheros AG71xx.
When I use my first network interface with:
root@rome03:~# ethtool eth0
Settings for eth0:
Supported ports: [ ]
Supported link modes: 1000baseT/Full
Supported pause frame use: No
Supports auto-negotiation: No
Supported FEC modes: Not reported
Advertised link modes: 1000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: No
Advertised FEC modes: Not reported
Speed: 1000Mb/s
Duplex: Full
Port: MII
PHYAD: 0
Transceiver: internal
Auto-negotiation: on
Current message level: 0x000000ff (255)
drv probe link timer ifdown ifup rx_err tx_err
Link detected: yes
Folgender Kernel ist installiert:
root@rome03:~# uname -r
4.14.167
I found the following page on the net:
[type or paste code here](https://lkml.org/lkml/2019/10/29/269)
On the website I find the following note: "net: stmmac: Do not stop PHY if WoL is enabled"
Why can't the network adapters do WOL?
Do I have to install a newer kernel?