TP-Link Archer C50 (CA) V6.0 full dump needed

[VE2PF]

Anyone have a full dump of this router?

I totally bricked mine and it wont even make it to load uboot. I have no output from the console and the led flash in the same pattern every few second.

I already tried to rebuild the flash by inserting the binary at the good place in the flash but to no avail.

[VE2PF]

forgot to say that I have the flash chip in my programmer and I made a litle jig to move the flash from my Xgecu to the board easily.

[brada4]

You are on your own, that device runs vxworks and with 4mB flash will never run OpenWrt.

[frollic]

Sure ?

Installing OpenWRT on TP-Link Archer C50 v6 (Tutorial)

Device : TP-Link Archer C50 V6 Region: IN OpenWrt Version : Snapshot The first time I tried installing OpenWRT, i messed up and bricked my router beyond soft repair and I had to flash the firmware using UART. But since then I have done this twice, on different routers, and had no problems. I am saying this so you know what you are going into. Mistakes can happen so have some failsafe ready just in case. But don't worry follow the steps carefully and you would be running openwrt on your router…

@VE2PF check if these can help Archer C50 V6 - MT7628AN.

[VE2PF]

Thanks or the links but after opening the c50 bin file in HxD, the fact that the flash is empty from h0 to h20000 tell me that there is no boot loader in the bin. And from what I can see it is that exactly what I am missing from my flash chip.

[frollic]

Bootloader can be extracted from the TP-Link image, that's how the initial OpenWRT cross flash image is built ...

[VE2PF]

I dont get it. What image are you talking about?