I am looking for tl-wr841n(es) ver: "13.0" stock firmware to install back on the device.
I am looking for the Spanish version of the router firmware for hardware version 13.0
I have found English, French and Portuguese and I have Spanish for hardware version 14.0 but nothing in Spanish for hardware version 13.0
Anyone happen to have a copy they can share as it does not seem to be downloadable.
If OpenWRT language pack does not fit in flash , Mexicans come to rescue. Spain has English, better that if you have EU bought device.
Spanish lanhuage pack on luci takes approx 100kB,
Thanks for the link. Hopefully the Mexico one will get it out of boot loop.
Bought in Colombia but no support here for some reason. 
You can try openwrt and relatively small web ui language pack
I am putting it back to stock to sell it.
That is what was on it when I used it for a short period of time.
So what I am reading here: https://openwrt.org/toh/tp-link/tl-wr841nd
Is that the stock firmware file is too big and needs to be stripped back? Of course there are some links provided but they no longer work.
Where did you get that t-rex image from? Perhaps I can install it using the TFTP method?
Well it is just OpenWRT 24.10-SNAPSHOT with luci-theme-openwrt-2020 and Español language pack. Should be almost same with 23.05.5 (or do # auc -B 24.10-SNAPSHOT)
The bootloader is at the start of OEM upgrade file, while sysupgrade comes without it, so you need to trim off bootloader and upload only the linux part via openwrt sysupgrade.
The wr841n is in bootloop at the moment. So only way I see possible to flash is tftp method. Is this the version you are referring to: https://firmware-selector.openwrt.org/?version=24.10.0-rc2&target=ramips%2Fmt76x8&id=tplink_tl-wr841n-v13
tftp needs full image, like oem bin or openwrt factory (in no event sysupgrade)
you see tftp parameters using wireshark.
That's what I thought from following along with this video link but it is not working for me on my version 13.
I tried both IP addresses that they say the v13 might use and have had not luck getting openwrt firmware to load. 
You can check with wireshark/tcpdump if anything is sent on lan1 or lan4 during boot with button pressed.
Or - how did you break it?
I broke it trying to flash back a stock firmware file. I have not tried another port other than lan port 1
It is first or last or any lan port.
So you flashed stock via sysupgrade and now you have 2 bootloaders in a row?
