While doing a speedtest with 1 Gbps download and 700 mbps upload
Last stable OpenWRT, dumb AP
mt7915_phy1-isa-18000000
Adapter: ISA adapter
temp1: +72.0°C (high = +120.0°C, crit = +110.0°C)
cpu_thermal-virtual-0
Adapter: Virtual device
temp1: +71.5°C
mt7915_phy0-isa-18000000
Adapter: ISA adapter
temp1: +72.0°C (high = +120.0°C, crit = +110.0°C)
Cudy now offer a signed openwrt, but first need an official openwrt firmware
¿A vicious circle?
Dear Customer,
Thank you for contacting Cudy support team.
For now, the OpenWRT forum doesn't release the OpenWRT firmware. So there is no need to offer the intermediate firmware to remove signature check. We will release the firmware after OpenWRT forum releases the OpenWRT firmware.
Their interim fw is already published ?
Hi.
What performance can be expected while using Wireguard on this device?
Hi team,
Couldn't find information about this model anywhere : Cudy WR3000S
mediatek filogic 820
128 flash
5 ports..
any chance it will be supported at all ?
thank you for not searching https://forum.openwrt.org/search?q=Cudy%20WR3000s%20order%3Alatest
Hi, please see in the first post: https://forum.openwrt.org/t/a-wireguard-comparison-db/187586
Kr
K
It has just been added in main snapshot.
which means files are available at https://firmware-selector.openwrt.org/?version=SNAPSHOT&target=mediatek%2Ffilogic&id=cudy_wr3000s-v1
keep in mind: https://openwrt.org/releases/snapshot
It's also going to be also built for 24.10.0-rc1
I've tested 24.10 now on a Cudy WR3000v1 and got a strange wifi troughput issue.
LAN -> WLAN I get 1Gbit, WAN -> WLAN I get only 200Mbit downstream, regardless if hardware offloading etc is enabled or not. With 23.05 the througput was 1Gbit up and down.
I just installed snapshot build and I get assigned random mac address to the ethernet interface on each boot. I had to set the mac address manually.
