Did anyone had a look on this device? Got mine new, it's pretty cheap and got nice specs. It has a OpenWRT running, so it should be possible to get a vanilla OpenWrt on it. What do you think? 1.3 GHz Dual-Core Cortex-A53 CPU Super-Fast AX3000 WiFi 6 Speeds 4× Gigabit Ports 4× High-Gain Antennas an…

It has just been added in main snapshot. mediatek: filogic: add support for Cudy WR3000S v1 committed 07:24PM - 23 Nov 24 UTC (UTC) [igieon] igieon +301 …

Folks, you look like an Expert in the wireless router. I am still determining even if I am wrong or right place. I am comparing the TP-Link Archer AX23 vs. Cudy WR3000. I need clarification about choosing a router between Cudy WR3000 and TP-Link Archer AX 23. Please suggest which router will be bes…

Can someone tell me what the TFTP recovery IP address is I have managed to brick my router. Trying to flash across to the latest firmware from the link above for RC3 resulted in me getting a router that fails to boot and does not give an IP address from the DHCP. I have manged to work out the recove…

@HerbyKowalski Factory recovery procedure is described under this link WR3000 (V1) OpenWrt @rajib WR3000 is based on newer and fastest hardware in compare to AX23 . Choice between two is easy : WR3000

@nicefile Thanks for your Advice :slight_smile:

I have tried the factory reset process. Although I do not have a Windows machine so I have tried TFTP Put from a Mac, it should be exactly the same process but at best all I have been able to achieve is a request timeout which either means (generally) that the request took too long to process or tha…

So serial console is your only hope then. Look for the steps I've did [image] Support for Cudy WR3000 For Developers So I have it strip open . Serial on the bottom of the board in the middle "□○○○" TX/RX/GND/3.3V 115200 full boot log: https://pastebin.com/FZM4bKaY Con…

FYI it brings up the flashing blue light when I hold both the power and reset button so uboot is present. Its just not giving an IP via DHCP, or otherwise. Do I have to do any soldering to use the serial console?

That is correct...you have to set an fixed ip adress in your network card and point to a certain ip adress in TFTP. There is a guide in the recovery directory of the Cudy openwrt build how to set it up. Go to: https://www.cudy.com/openwrt_software_download with your normal desktop browser, or set …

I downloaded and I'll say this - I don't know if it's only happening to me, but I can't turn on width 160. Neither the laptop nor the phone sees the network after that and on the router it shows that the network is disabled. In addition, the system is read-only Did you manage to fix it? I have th…

Ahh thanks for confirming, thats how i fixed it but didnt know how lol. Suddenly the problem was away but couldnt recall what i changed.

Support for Cudy WR3000

For Developers

nicefile September 6, 2023, 5:37am 72

So serial console is your only hope then. Look for the steps I've did

and then load image openwrt-23.05.0-rc3-mediatek-filogic-cudy_wr3000-v1-initramfs-kernel.bin via tftp

Then when Your device is booted You flash openwrt-23.05.0-rc3-mediatek-filogic-cudy_wr3000-v1-squashfs-sysupgrade.bin