I found a bug lol. I forced it to uboot console bypassing the password screen. Now i'll play around to see if I can get somewhere. tftpboot has been disabled. (the command)
However usbboot seems to respond.. I'll try figure something out tomorrow
U-Boot 1.3.3 [spf11.1_csu2] (Jan 27 2021 - 09:14:27 +0000)
DRAM: smem ram ptable found: ver: 1 len: 4
2 GiB
[Askey] Led init ...
NAND: Could not find nand_gpio in dts, using defaults
Not an ONFI device
ONFI probe failed
ID = ffffffff
Vendor = ff
Device = ff
qpic_nand: unknown NAND device manufacturer: ff device: ff
U-Boot BUG at drivers/mtd/mtdcore.c:420!
SF: Unsupported flash IDs: manuf ff, jedec ffff, ext_jedec ffff
ipq_spi: SPI Flash not found (bus/cs/speed/mode) = (0/0/48000000/0)
0 MiB
MMC: <NULL>: 0 (eMMC)
In: serial@78B3000
Out: serial@78B3000
Err: serial@78B3000
machid: 8750106
eth5 MAC Address from ART is not valid
Hit space key to stop autoboot: 0
Unknown command 'fatload' - try 'help'
Net: MAC0 addr:2c:ea:dc:34:4a:ab
PHY ID1: 0x4d
PHY ID2: 0xd0b1
PHY ID1: 0x4d
PHY ID2: 0xd101
EDMA ver 1 hw init
Num rings - TxDesc:1 (0-0) TxCmpl:1 (7-7)
RxDesc:1 (15-15) RxFill:1 (7-7)
ipq807x_edma_alloc_rings: successfull
ipq807x_edma_setup_ring_resources: successfull
ipq807x_edma_configure_rings: successfull
ipq807x_edma_hw_init: successfull
eth0
IPQ807x#