Hi I am using gl-inet-ar150 soc 9330 openwrt my build using kernel 4.9
CONFIG_TARGET_ar71xx=y CONFIG_TARGET_ar71xx_generic=y CONFIG_TARGET_ar71xx_generic_DEVICE_gl-ar150=y CONFIG_COLLECT_KERNEL_DEBUG=y CONFIG_KERNEL_DYNAMIC_DEBUG=y CONFIG_KERNEL_DYNAMIC_FTRACE=y CONFIG_KERNEL_ENABLE_DEFAULT_TRACERS=y CONFIG_KERNEL_FTRACE=y CONFIG_KERNEL_FTRACE_SYSCALLS=y CONFIG_KERNEL_FUNCTION_GRAPH_TRACER=y CONFIG_KERNEL_FUNCTION_PROFILER=y CONFIG_KERNEL_FUNCTION_TRACER=y # CONFIG_KERNEL_KALLSYMS is not set CONFIG_PACKAGE_ethtool=y CONFIG_PACKAGE_iftop=y CONFIG_PACKAGE_iperf3=y CONFIG_PACKAGE_iputils-arping=y CONFIG_PACKAGE_iputils-ping=y CONFIG_PACKAGE_iputils-traceroute6=y CONFIG_PACKAGE_libncurses=y CONFIG_PACKAGE_libpcap=y CONFIG_PACKAGE_libsysfs=y CONFIG_PACKAGE_netcat=y CONFIG_PACKAGE_terminfo=y
when connecting to an existing router Lan port
and having in etc/config/network
config interface 'lan' option type 'bridge' option ifname 'eth0' option proto 'dhcp' option gateway '18.104.22.168' option netmask '255.255.255.0'
I don't have any problem at all to connect to internet through
the gl-inet-ar150 wifi bridged lan
router ----eth cable--- gl inet ar150 ---- wifi radio ---my PC
I can even set the router to gave my gl inet ar150 a specific IP address based on MAC .
I can then acces my gl-inet-ar150 by ssh at port 22.
What is driving me crazy is that if I use (as I have always been doing to configure my gl inet ar150)
a set up where I have
gl inet ar150---wifi ---my Pc
I am able able to access the router on port 22 by ssh
gl inet ar150 -----eth cable--- my PC
with etc/config/network (same as gl inet ar150---wifi ---my Pc settings)
config interface 'lan' option type 'bridge' option ifname 'eth0' option proto 'static' option ipaddr '22.214.171.124' option netmask '255.255.255.0'
and then I tell my PC with manual iPv4 setting
being 126.96.36.199 as IP name
and netmask 24 (255.255.255.0)
and gateway 188.8.131.52
I won't be able to access the router on port 22 by ssh.
Strange thing is that the eth link is up,
my PC isnt able to connect to gl inet ar150: if I ping 184.108.40.206 from PC I got unreachable host
but if I ping my PC from gl inet ar150 (serial console) even just once (ping 220.127.116.11) the I can ping back
from my PC to gl inet ar150 and I can connect by ssh to my gl inet ar150 from my PC on port 22 .
What is different between the two set ups ?? What I am missing about router advertising ??
I should point out that my special setting has only a eth0 device as per my
where I get hopefully the router using only one MAC controller that goes to the switch where
I can see port 1 and port 5 as the two rj45 plug named lan and wan in the original normal openwrt settings).