[Solved] Adsl connected but no internet - TP-LINK td-w8980

Hello, I installed lede 17.01.4 on my modem-router tp-link td-w 8980. The firmware I installed is the sysupgrade.
I configured everything to connect to my ADSL2+ through pppoe , annex a, I put all the correct data, including username , password etc.. I'm able to connect to ADSL , it says status up and Showtime, but there's no internet .
In the overview , it says wan ipv4 not available, and in interfaces wan always remains at zero, no packets sent or received.
I tried changing physical device in wan, putting ptm0, nas0, eth0 ...always same result. I also tried deleting ATM bridge but still no success , and also changing protocol to pppoa I still don't have internet.
I post my config and system log .

My config https://pastebin.com/X0UWhVqr
System log https://pastebin.com/UXPJtaYE

Thank you for reading. Tommy

I don't see any DNS servers configured for the WAN interface.

1 Like

I did everything with luci, I left the "carrier dns" option on. I also tried adding Google dns with no luck. Thanks

I'm in Italy, I put the correct vpi and vci , 8 and 35.

Thanks

I would recommend resetting LEDE to factory and re-configuring with just the basics.

1 Like

I tried, I also reflashed the firmware through web interface to be sure but still the same problem. I remember that on first boot I always have to delete the rootfs data partition because otherwise it doesn't save settings. Thanks

SSH in to the TD-W8980 and run this...

dmesg | grep 'warn\|err'
1 Like

I was finally able to connect changing protocol in pppoa and deleting ATM bridge :blush: Thank you for your help

I did everything with luci, I left the "carrier dns" option on. I also
tried adding Google dns with no luck. Thanks

This topic was automatically closed 10 days after the last reply. New replies are no longer allowed.