Reset command - LEDE 17.01.2 with Omega2+ **SOLVED**

Installing and Using OpenWrt
1

Hi,

After changed my Omega2+ original firmware to LEDE 17.01.02, I saw that reset command doens't works.

Output from serial console:

reboot
[   66.947840] br-wlanap: port 2(wlan0-1) entered disabled state                                                                              
[   66.953827] br-wlanap: port 1(eth0.1) entered disabled state                 
[   67.000036] device eth0.1 left promiscuous mode                              
[   67.004716] device eth0 left promiscuous mode                                
[   67.009262] br-wlanap: port 1(eth0.1) entered disabled state                 
[   67.091928] IPv6: ADDRCONF(NETDEV_UP): eth0.1: link is not ready             
[   67.122954] device wlan0-1 left promiscuous mode                             
[   67.127753] br-wlanap: port 2(wlan0-1) entered disabled state                
[   68.412830] wlan0: deauthenticating from 84:16:f9:98:43:08 by local choice (Reason: 3=DEAUTH_LEAVING)
[   71.426685] reboot: Restarting system

After this the yellow led turn off and nothing happens.
Someone had this issue?

2

Sometimes reboot doesn't work right. This functionality is not a top priority for an embedded system that is always on.

Does it matter? You can just power-cycle the device when the LED turns off.

LP,
Jure

3

Isn´t so easy to turn off because the device is installed on the client.
I can't call him and ask to turn off.

4

Is there a reason why you use a deprecated 17.01.2 release, when there is much newer 17.01.4 available.
You might try the latest 17.01 release first...

1 Like
5

Ok, I will try 17.01.4.

6

Only to close the topic.

Version 17.01.04 has the same problem, reboot command doen't work correctly.
But there is a patch to fix him.
https://patchwork.ozlabs.org/patch/713750/

I applied, build and now works fine.

Thanks.

1 Like
7

This topic was automatically closed 6 days after the last reply. New replies are no longer allowed.