Reinstalling kmod-ath10k-ct and ath10k-firmware-qca9888-ct behind the proprietary version

Installing and Using OpenWrt Network and Wireless Configuration
1

Hello everyone, I reinstalled ath10k-board-qca9888 with drivers open for closed and the same with kmod-ath10k but since I reset it the 5ghz doesn't want to work and after checking the config I found that I have almost no config for radio0 , so I looked around the internet and put a config there that should be correct, but it probably isn't, because after I checked the logs, it throws an error on radio0, tries to start it several times and then puts it in down mode, so the question is what should I do about it and what else should I check?

2

checked the system log post boot ?

3

Is that system log or kernel log?

4

OK, I something find

Tue Aug  1 17:08:33 2023 kern.info kernel: [   15.528094] ath10k_pci 0000:00:00.0: enabling device (0000 -> 0002)
Tue Aug  1 17:08:33 2023 kern.info kernel: [   15.534905] ath10k_pci 0000:00:00.0: pci irq legacy oper_irq_mode 1 irq_mode 0 reset_mode 0
Tue Aug  1 17:08:33 2023 kern.info kernel: [   17.168197] ath10k_pci 0000:00:00.0: qca9888 hw2.0 target 0x01000000 chip_id 0x00000000 sub 0000:0000
Tue Aug  1 17:08:33 2023 kern.info kernel: [   17.177782] ath10k_pci 0000:00:00.0: kconfig debug 0 debugfs 1 tracing 0 dfs 1 testmode 0
Tue Aug  1 17:08:33 2023 kern.info kernel: [   17.198110] ath10k_pci 0000:00:00.0: firmware ver 10.4-3.9.0.2-00157 api 5 features no-p2p,mfp,peer-flow-ctrl,allows-mesh-bcast,no-ps,iram-recovery crc32 812c4602
Tue Aug  1 17:08:33 2023 kern.err kernel: [   17.562569] ath10k_pci 0000:00:00.0: failed to fetch board data for bus=pci,bmi-chip-id=0,bmi-board-id=20 from ath10k/QCA9888/hw2.0/board-2.bin
Tue Aug  1 17:08:33 2023 kern.err kernel: [   18.177759] ath10k_pci 0000:00:00.0: failed to fetch board-2.bin or board.bin from ath10k/QCA9888/hw2.0
Tue Aug  1 17:08:33 2023 kern.err kernel: [   18.187514] ath10k_pci 0000:00:00.0: failed to fetch board file: -12
Tue Aug  1 17:08:33 2023 kern.err kernel: [   18.208845] ath10k_pci 0000:00:00.0: could not probe fw (-12)
5

Resetting to defaults might be easier...

6

I understand, it's the easiest, but I'd like to solve it, because there's still a bug with the drop of the 5GHz networks on that router