Good morning everyone,
I have a TP-Link brand Access Point model "Archer C6 Gigabit Router Wi-Fi Dual Band AC1200 Wireless", on this I have installed OpenWrt and configured my VPN, in my case Cyberghost but NordVPN and similar are also fine and I have no problems with sort of, okay it's fast and it does the job but ALL traffic goes to the VPN.
For logistical reasons, however, I would like to replace it with another model c but I would like this one to have these characteristics:
could have 2 wireless lines, a VPN and a normal one;
possibility of configuring the Ethernet ports, what do I know about 1 being the VPN and the others being normal ISP traffic.
Is this possible?
Can you recommend a model with enough memory to use "policy based routing"
Thank you so much
You can add extra Wi-Fi SSID for normal traffic and an Ethernet port
just need to attach them to the correct interface
try adding another Wi-Fi channel to LAN as I think VPN would be using a tap interface
should all work with current router
Your limitation is flash i.e permanent memory, known as hard disk in a pc, where you are trying to install VPN software and it leaves no place for pbr.