I think I have a very serious problem with my NAND memory.
Just starting directly from NAND memory and connected to the serial port (which works beautifully and simply by connecting a USB-C cable to my computer) I have the following serial output:
TICE: UBI: Bad EC magic in block 2028 ffffffff
NOTIC UBI: ad Cmagic in block 2029 ffffffff
OTICE: UBI: Bad EC magic in block 2030 ffffffff
OTICE: UBI:Bad EC gic in block 2031 ffffffff
OTICE: UBI:BadCm lo32 ffffff
TIE: UBI: Bad C gi inblock2033 ffffffff
TICE: BI: ad ECmagic in block 234 ffffffff
OTICEUBI: Bad Emagic bock 203ff
ICE: UBI: Bad EC magic in block 2036 ffffffff
TICE: UBI: Bad EC magic in block 2037 fffffff
E:U bckffCEd lock 2039 4e4d4d30
NICE: UBI: scanning hedTI UBsize: 131072 bytes (128iB, LEB size: 126976 bytes
NOTICE: UBI: VID header offset: 2048 (aligned 2048), da offset: 4096
Eofip (Id #29761NOTICE: BL2:ng BL31
OT:(rlease):OpenWrt v2023.10.13~0ea67d-1 (mt798u : Built : 09:3538, May 21 2024
Trying full recovery I have the following error in the serial:
starting USB...
Bus xhci@11200000: xhci-mtk xhci@11200000: hcd: 0x0000000011200000, ippc: 0x0000000011203e00
xhci-mtk xhci@11200000: ports disabled mask: u3p-0x1, u2p-0x0
xhci-mtk xhci@11200000: u2p:1, u3p:1
Register 200010f NbrPorts 2
Starting the controller
USB XHCI 1.10
scanning bus xhci@11200000 for devices... 1 USB Device(s) found
scanning usb for storage devices... 0 Storage Device(s) found
** Bad device specification usb 0 **
Couldn't find partition usb 0:1
Can't set block device
I loved the serial console interface... will I have to upload the firmware via tftp?
