@lleachii
I think I did.
@mk24
alright. how do i do the dns thing?
and yes, i have fixed it to be 192.168.5.5.
I reached my post limit. I'll try all of your suggestions. How do I renew dhcp?
Okay, reset the leases. Still no internet.
1 Like
I assume the OP is plugged into eth0 - upstream (where is the switch).
If you just did it, ALL leases must be renewed ON ALL CLIENTS.
No.
Only one port.
Yes, I know it's one port, but is it possible that for some reason VLAN is enabled, but eth0 and LAN aren't on for the same VLAN?
Reset all network interfaces - wired and wireless. Reboot the Dumb AP, etc.
Tru...but default lease on OpenWrt is 12 hours, this issue must be eliminated 1st for the OP.
Please refrain from editing posts to show future events.
We'll have to resume later - or wait until you perform other tasks to increase your user level.
1 Like
This device does not have a switch chip (the AR8035 is a one-port PHY chip only), so VLANs would only need to be set up directly on eth0. Using plain eth0 with no VLAN number means that untagged packets will go out on the cable.
I would also make sure the IPv6 DHCP server is disabled, this is a separate tab on the DHCP section at the bottom of the LAN network configuration page.
Check network status on the end-user devices to see that they are properly DHCP configured.
3 Likes
Okay, I'm back. I'm not sure if DHCP on the computer is the issue, since my router doesn't even detect the device. However, the lan port works since the AP can tell when i turn on/off the router.
Could you try another cable?
tried 
Ok it's getting a bit confusing. You have Router, AP and PC.
As I understand, router is 192.168.5.1, AP is 192.168.5.5. Let's set the PC to static IP of 192.168.5.10.
Connect the PC directly to the router. Can you ping it?
Connect the PC to the AP. Can you ping it? Can you ping the router?
I can ping the router without issue.
I can ping the AP directly when I'm connected to it directly, but not when both the PC and AP are connected to the switch.
Let's remove the switch now to simplify things.
Disable DHCP on the AP, connect it to the router and see if you can ping the router from the LuCI or SSH.
Didn't work.
Have you disabled DHCP on the AP?
Can you ping the AP if connected via cable or WiFi?
yup, i have.
yes, i can ping the AP from my computer over cable or wifi.
I can't think of any thing else other than making sure that the cable between the router and the AP is gigabit cable.
how would i tell?