Hello, just a little note.
I've got some MR8300. I've bricked one of this with a wrong command (don't do a fw_setenv kernsize=500000 !!! Don't use = or the next start won't boot!)
Opening an MR8300: 4 screws in the bottom (under the rubbers) then open gently the cover on the top.
What the log output from uart do you have, I would like to see what is the output when the MR8300 switch to 02 partition after sysupgrade, what is the error reported
Hi.
I have photos for PCB, opening case and UART pins, but I haven't the right to add them to the TOH.
May I send them to you? I have already updated the text infos for the matter.