No ping to fritz 7530

[dax79]

Hi, i switch through web interface from dhcp client to static ip address on my fritz 7530. I was thinking about something else and i set just the ip address (192.168.80.1), neither netmask nor gateway.

Now i wasn’ t able to reach it, is there any way to fix it without loosing configuration?

Unfortunately i have not a backup.

Thanks

Davide

[Aikon]

[OpenWrt Wiki] Failsafe mode, factory reset, and recovery mode

Go into failsafe and edit the IP settings.

[lleachii]

@dax79

i switch through web interface from dhcp client to static ip address on my fritz 7530.

Only the WAN interface is DHCP Client by default. WAN is also inaccessible by default firewall configuration.

@dax79

Now i wasn’ t able to reach it

Are you connecting locally or remotely over the Internet?

[dax79]

@Aikon

Go into failsafe and edit the IP settings.

I will look, thanks. No configuration losing?

@lleachii

Only the WAN interface is DHCP Client by default. WAN is also inaccessible by default firewall configuration.

Wan interface is (was) configured for my internet provider. Can i connect by cable directly from wan to pc?

@lleachii

Are you connecting locally or remotely over the Internet?

Locally

[dax79]

I use failsafe mode to fix the problem, without loosing configuration.

Thanks

[_bernd]

Ipv6 link local with ssh is mostly an option too if you screw up ipv4 config.

[dax79]

Thanks, good hit.