Hi all,
I need to do RF testing for AR9331 module using ART2 tool.
Firmware version: 19.07.7
Board:AR9331
Please let me know how to test AR9331 module using ART2 tool, and also let me know where would I get the firmware for the same
Hi all,
I need to do RF testing for AR9331 module using ART2 tool.
Firmware version: 19.07.7
Board:AR9331
Please let me know how to test AR9331 module using ART2 tool, and also let me know where would I get the firmware for the same
OpenWrt doesn't include ART2 tool and support for it in drivers.
You should contact your hardware manufacturer and/or Qualcomm distributor for support.
Is there any way for RF testing for the following points as mentioned below,
DUT in TX Mode command: Transmit in Un-modulated (Single tone carrier) continuous
wave(CW) and modulated mode (Both)
TX Power level adjustment command: User configurable output power step (Increment and
decrement step of 1dB)
Start & Stop command: Provide support to user start and stop TX Mode.
Channel Access command : 2.4 GHz band (WiFi band) as seen below table.
Supported Data Rates command :
802.11b: 1,2,5.5,11 Mbps
802.11g: 6,9,12,18,24,36,48,54 Mbps
802.11n : 6.5 Mbps -130 Mbps (20MHz), 13.5-300 Mbps (40MHz)
Please let me know how to test the following points in AR9331 module
Thanks,
Dhawal Umesh Lad
@pepe2k ,
Thanks for your promp response.
We have already tried with them but not getting proper support for the same. So that we are asking if any opensource tool available for the same which would be helpful for us to move further.
Regards,
Ritesh Prajapati
I'm not aware of any open source tool for that.