so I tried the new 23.05.3 today and the issue is still present.
One thing I had noticed in LuCI was the missing encryption option under the 'wireless security' tab, same as in 23.05.2, but after installing wpad, and some other packages, I can now select password encryption.
However, under advanced settings for the wireless interface configuration, it still is showing undefined mac address.
Running iwinfo shows the mac address of the wlan0 and wlan1 but it takes close to 2 minutes to load the output (very strange, should be instantaneous).
Any suggestions what I might be doing wrong?
It hangs just after this line:
Tx-Power: 3 dBm Link Quality: unknown/70
the whole output is:
wlan0 ESSID: unknown
Access Point: XX:XX:XX:XX:XX:XX
Mode: Client Channel: unknown (unknown) HT Mode: NOHT
Center Channel 1: unknown 2: unknown
Tx-Power: 3 dBm Link Quality: unknown/70
Signal: unknown Noise: unknown
Bit Rate: unknown
Encryption: unknown
Type: nl80211 HW Mode(s): 802.11ax/b/g/n
Hardware: 14C3:7915 14C3:7915 [MediaTek MT7915E]
TX power offset: none
Frequency offset: none
Supports VAPs: yes PHY name: phy0
wlan1 ESSID: unknown
Access Point: XX:XX:XX:XX:XX:XY
Mode: Client Channel: unknown (unknown) HT Mode: NOHT
Center Channel 1: unknown 2: unknown
Tx-Power: 3 dBm Link Quality: unknown/70
Signal: unknown Noise: unknown
Bit Rate: unknown
Encryption: unknown
Type: nl80211 HW Mode(s): 802.11ac/ax/n
Hardware: 14C3:7915 14C3:7915 [MediaTek MT7915E]
TX power offset: none
Frequency offset: none
Supports VAPs: yes PHY name: phy1