Mesh point capable chipsets list?

I know I need "mesh point" in the output of "iw list", but I have not seen a database of sorts for which cards will do it.

 Supported interface modes:
             * ...
             * ...
             * mesh point <-- THIS ONE
             * ...
             * ...

Right now I only got MT7610U and MT7612U but these are quite old and slow for my needs. Anyone know of any useful resources? I want to use cheap-ish SBCs to make my own APs with known good, upgradable, supported software. Any help is appreciated.

mt76-any
ath9k
ath10k
ath11k (a bit buggy sometimes)
ath12k (lots of rough edges)
Most others advertise capability, but ymmv

Making sbc into wifi access point doubles price, better but mid-to-high range router based on filogic chips.

I'm currently interested in Wifi 6/6E/7 chipsets. If I understand this correctly, IBSS mode(which is supported by virtually all) plus batman+batman-adv or yggdrasil should work if all mesh nodes "sees" the gateway(no packet forwarding), but 802.11s is a lot more flexible so I'll focus on that.

From what I can gather:
MT7921 does not support mesh (https://github.com/openwrt/mt76/issues/653)
MT7996E does not support mesh (https://github.com/openwrt/mt76/issues/961, https://bpa.st/25NQ)
WCN7850 (QCNCM865) does not support mesh (https://forums.servethehome.com/index.php?threads/802-11be-the-cheap-way-40.42112/page-4)

Others:
MT7915 supports mesh (https://github.com/dangowrt/owrt-ubi-installer/issues/27)
MT7916 supports mesh (https://github.com/openwrt/openwrt/issues/17632)
MT7603, MT7615 supports mesh (Installing OpenWrt on UniFi nanoHD - #43 by vultux)
Mt7603,MT7612 supports mesh (Hardware recommendations for mesh network (802.11s))

AC/ath10k:
QCA9563, QCA9880, QCA9984, IPQ4018 supports mesh (OpenWrt 18.06.1: Unable to negotiate with [IP-address] port 22: no matching host key type found. Their offer: ssh-rsa - #16 by slh)

AC/marvell:
88W8864 probably does not work (Trouble getting batman-adv working - #30 by Markinus)
88W8964 does not work (https://github.com/kaloz/mwlwifi/issues/359)

AC/Broadcom:
BCM4366B1, BCM4366C0 does not work (ASUS RT-AC88U/broadcom WDS)
(I'm going to just keep editing this list here)

MT7996E (Banana Pi BPI R4, ASUS Zenwifi BT8) does support "mesh point"

0000:01:00.0 Network controller: MEDIATEK Corp. Device 7990
	Subsystem: MEDIATEK Corp. Device 6639
	Device tree node: /sys/firmware/devicetree/base/soc/pcie@11300000/pcie@0,0/mt7996@0,0
	Flags: bus master, fast devsel, latency 0, IRQ 121
	Memory at 30200000 (64-bit, prefetchable) [size=2M]
	Memory at 30400000 (64-bit, non-prefetchable) [size=32K]
	Capabilities: [80] Express Endpoint, IntMsgNum 0
	Capabilities: [e0] MSI: Enable+ Count=1/32 Maskable+ 64bit+
	Capabilities: [f8] Power Management version 3
	Capabilities: [100] Vendor Specific Information: ID=1556 Rev=1 Len=008 <?>
	Capabilities: [108] Latency Tolerance Reporting
	Capabilities: [110] L1 PM Substates
	Capabilities: [200] Advanced Error Reporting
	Capabilities: [300] Secondary PCI Express
	Kernel driver in use: mt7996e
	wiphy index: 0
	max # scan SSIDs: 4
	max scan IEs length: 2131 bytes
	max # sched scan SSIDs: 0
	max # match sets: 0
	Retry short limit: 7
	Retry long limit: 4
	Coverage class: 0 (up to 0m)
	Device supports AP-side u-APSD.
	Device supports T-DLS.
	Available Antennas: TX 0x3 RX 0x3
	Configured Antennas: TX 0xff RX 0xff
	Supported interface modes:
		 * IBSS
		 * managed
		 * AP
		 * AP/VLAN
		 * monitor
		 * mesh point
		 * P2P-client
		 * P2P-GO