Hi all,
I've been working on getting current OpenWrt running on the Huawei MA5671A, and it's now at a point where it's usable, so I'm sharing it. It's based on OpenWrt 25.12 with kernel 6.12 (lantiq/falcon). As far as I know, the images people run on this stick are still the old 14.07_ltq / kernel 3.10 builds with Lantiq's closed OMCI stack.
I ported the Lantiq 4.5.0 ONU and optic drivers (the dual BSD/GPL ones from osmocom) to 6.12. I also replaced IFXOS, which has no licence, with a small clean-room layer and wrote a new OMCI daemon from scratch. On top of that there are packages for the GPON identity (serial, PLOAM password, vendor, MACs), SFP EEPROM emulation, SIP voice through the stick, a trial boot that falls back to the stock image if you don't confirm, and some LuCI pages.
So far I've only tested it on my own stick with my ISP (Antel, Uruguay, Huawei OLT). It ranges to O5, PPPoE works through the stick at around 650 Mbit/s down, and SIP voice works through siproxd and FreePBX. I have no idea yet how it behaves with other OLTs.
There are two important caveats. First, you need a stick that's already rooted. Second, the packet engine still needs Lantiq's proprietary microcode, and its licence doesn't allow redistribution. Because of that I'm not publishing images: you build your own with your unit's data (MAC, EEPROM, optical calibration). The getting started doc in the repo goes through the whole process. The stock image stays in image0 as the way back. Do your first tests with the fibre disconnected, because a bad optical calibration can damage the laser.
I designed it and did all the testing on real hardware, but a large part of the code was written with AI coding agents, as explained in the README. Please review it before trusting it, especially anything on the optical side.
What would help most right now is people testing on other ISPs and OLTs (ZTE, Nokia, other Huawei setups), ideally with OMCI traces with the serial, PLOAM password and SIP credentials removed. Longer term, I'd like to replace the proprietary microcode and the stock U-Boot. If anyone has experience with either, I'd be glad to hear from you.
Some of the docs are still in Spanish, I'm translating them.
Feedback and PRs welcome.