Daarke
1
Need help getting my router back to stock firmware.
Tried getting WireGuard to work with no luck, thought i could make it into a vpn Router.
The 3x 2 second on/off procedure didn't seem to work, only boots up in openwrt.
Is there an easy way to getting back to stock firmware?
'The 3x 2 second on/off procedure' you quoted is not for EA6350 v3.
In wiki page below, refer to 'Recovery (Automatic)'
See 'Back to Stock' instructions if both partitions contains openwrt.
https://openwrt.org/toh/linksys/linksys_ea6350_v3
2 Likes
Daarke
3
Thank you! totally missed that
Edit: 15 sec on, 10 sec off three times did the trick I now toggled back to stock firmware.
system
Closed
4
This topic was automatically closed 10 days after the last reply. New replies are no longer allowed.