Hello,
today I changed my network setup and switched to lede 17.01.4 on my tp link wdr 3600n.
MY modem is a speedport w724v which doesnt allow me to disable NAT. thats why id'd like to use my lede router as suggested here:
https://lede-project.org/docs/user-guide/switch_router_gateway_and_nat
as a wire to wire switch with wlan access point. that would give me the best experience including gaming right?
How do i set this up using luci?
these are my current settings:
speedport has the ip 192.168.2.1 and dhcp enabled. 192.168.2.100-199
speedport is connected to wan port on tp link
in the setup for my tp link i changed the following:
interfaces--> lan disabled dhcp .
interfaces --> lan > physical settings bridge interface:checked: vlan eth0.1 ; eth0.2 ; wireless lede ; wireless network lede5ghz
With these settings i could not access the luci interface. so i changed the static ip of lan interface to 192.169.2.199. now i could open luci again.
now the wan and wan6 interfaced dont have ip adresses anymore, is that correct?
other problems:
the 5ghz network is enabled but there is no signal. is this a known error with the wdr 3600?
next i want to setup sqm is the possible using this setup and this guide?
https://lede-project.org/docs/user-guide/sqm
Thanks for your help!