Hi,
I am trying to setup IPv4+IPv6 (Dual Stack) and DHCP-PD, but the router does not get the IPv6 address. The carrier send the information using PPP. My configuration about interfaces is:
config interface 'wan'
option proto 'pppoe'
option username 'xxx'
option password 'yyy'
option mtu '1492'
option ipv6 '1'
option device 'eth0.6'
config interface 'wan6'
option proto 'dhcpv6'
option device '@wan'
option reqaddress 'try'
option reqprefix 'auto'
And the ifconfig show:
pppoe-wan Link encap:Point-to-Point Protocol
inet addr:x.x.x.x P-t-P:x.x.x.x Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1484 Metric:1
RX packets:25376 errors:0 dropped:0 overruns:0 frame:0
TX packets:26553 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:3
RX bytes:9002438 (8.5 MiB) TX bytes:4379979 (4.1 MiB)
Any ideas?
HW is TP-Link 3600 v1
Thanks!
Regards,
kix