Hello friends. I'm new in the forum, recently discovered this option to bring a new life to my old Mybooklive NAS. I have read the tutorial for installing the OS, and followed the steps. I first tried with an old 120 gb SATA SSD, and the system booted ok. I also have one 512gb and two 1tb hdd's which tested too. The 512 gb disk also booted, but the disk is in bad condition and can't be used to store data. When followed the tutorial with both of the two 1tb hdd's, the system does not boot. The blue light of the device turns on, and then goes off. I tried several times with the same result. When checking the partitions table of the 1tb disks, the size of the two partitions is greater than the 8mb and 104mb that are shown in the documentation. I asked chatgpt for help, and gave me a possible source of the problem: the sectors size. I believe that my 1tb disks have 4096kb sector sizes, which can't be read by the device. The 512gb HDD being older, and the SSD that probably have 512kb emulation are recognized. Does this have any sense to you guys? Am I right? Or the problem could be something else? What can I do to use those 1 tb disks with my device?