How to install OpenWrt on X6000R

Installing and Using OpenWrt
1

Hey, did you managed to load openwrt to X6000R? I have some issues. Thanks for reply in advance.

2

So far OpenWrt on the X6000R has been running smoothly for me. All the features I use are working properly, no major issues :+1:

3

Could you help me with installing OpenWRT to X6000R? I cannot load using web interface and failover/recovery mode is not working...

4

Sure, I can try to help. Could you tell me what steps you’ve already taken? It would be great if you can share the details :+1:

5

  1. Tried to load via web-page but had "Invalid upgrade firmware file." .

  2. Unplugged from power.

  3. Unplugged all LAN ports from X6000R

  4. Set NIC for 192.168.1.10 with 255.255.255.0 mask

  5. Plugged X6000R to power while holding RESET button with toothpick for 5-6 seconds until all LAN ports flashed green LEDs.

  6. Cannot enter 192.168.1.1 admin/recovery panel.

6

try the CVE exploit instead ?

7

Can you ping 192.168.1.1 at all?

Try repeating the procedure carefully like this:

  1. Prepare the OpenWrt sysupgrade image from the OpenWrt firmware selector page.
    NOTE: Make sure you use the sysupgrade file, not the kernel/initramfs one.
  2. Set up your computer network:
  • IP address: 192.168.1.x (any from .2 to .254)
  • Subnet: 255.255.255.0
  • Gateway: 192.168.1.1
  1. Unplug the router from power and connect your PC via ethernet cable to one of the LAN ports.
  2. Open cmd/terminal and start continuous ping:
    ping 192.168.1.1
  3. Press and hold the Reset button. When you see the LED blinking blue/red and then all LAN LEDs turn green, release the Reset button.
  4. If successful, you should start seeing ping replies. At that point, open http://192.168.1.1 in your browser and upload the firmware.

If this still doesn’t work, another option is trying a known CVE-based exploit method for this device—but that depends on the firmware version you’re currently running.