How to check if encryption is enabled on Mesh node

Hi fellow OpenWrt users,

I use a mesh of two Netgear R7800 devices as a wifi bridge. As recommended here I use the following packages:

ath10k-board-qca9984
ath10k-firmware-qca9984
kmod-ath10k
wpad-mesh-wolfssl

For the mesh nodes WPA3-SAE is selected as encryption method. It seems to work fine, but the in the wireless overview encryption is shown as None.
I already read something that the encryption status shown in the overview might not show the actual encryption. I would like to have some confirmation though to be sure the communication is actually encrypted. How could I prove this?

Thanks!

Related:

1 Like

This topic was automatically closed 10 days after the last reply. New replies are no longer allowed.