Help with the openwrt installation tutorial for SAX1V1R

Hardware Questions and Recommendations
1

Is there any big guy who can send me the openwrt installation tutorial of Spectrum SAX1V1R? Thank you

2

Are the V1R and V1K the same device?

3

There are a few differences to the V1K, including:

  • There's no pause in U-Boot
  • There's no password backdoor and pressing enter for a login prompt does nothing, but you can boot to a single user mode of sorts by pressing a key for fallback mode!
    You can read/write, but the UART drivers are buggy and it will constantly dump lines of text faster than the serial connection can display.
  • The U-Boot version is different and so is the firmware
  • The pinout for the UART is different: pin 1 is GND, 2 is TX, 3 is 3.3v, and 4 is RX.
  • I have no idea if this applies to the V1K but it's hilarious to see how connecting and disconnecting ethernet cables with the case on rubs against the case. It's very obvious that some bits of this design were half-baked, but this could apply to Spectrum's hardware in general.
4

Spectrum SAX1V1K (Askey RT5010W) OpenWrt Support - #132 by hurrian attempt on your own risk.

5

Thank you, but the two models are a little different, I can't enter u-boot, so I'm looking for help

6

Your device isn't officially supported by Openwrt, there's very little help we can provide.

1 Like
7

Thank you, if someone who uses this device sees this message, maybe he can help me