Hi, everyone :
I try to build wi-fi monitor system in my testing lab.
My hardware is RPi 4 Model B Rev 1.4 and Firmware Version is OpenWrt 21.02.3 r16554-1d4dea6d4f / LuCI openwrt-21.02 branch git-22.213.35964-87836ca.
And know how to config wilress interface to monitor mode and know some packages like as kismet ,Aircrack-ng, horst can monitor wi-fi , but they are only can get my want data via CLI( Command-Line Interface)
I would like build up the wi-fi monitor system , and can get same information (include client devics IP, connected AP Name,Protocol, Host Name, Connection Speed, SNR, Signal Strength, Usage, SSID, Uptime..etc) in OpenWrt as below snapshot capture from Cisco Aironet 2802 AP
Do anyone know any packeage or utility and show above informations via summay table or dashboard or graphic in LuCI webpage? Let people can clear to know wi-fi congestion degree/status at a glance.
Please kindly help me and forgive my bad english.
In Associated Stations setion only will show client list when wi-fi(wlan1) mode is Acess Point mode
I would like show nearby clients and APs informations (include client devics IP, connected AP Name,Protocol, Host Name, Connection Speed, SNR, Signal Strength, Usage, SSID, Uptime..etc) when wlan0 is Monitor/Sniffer mode.
My mention is not Scan Featur in radio 0 (wlan1) with Master mode
I would like to sniffer any neighbourhood wireless device (mobile phone, note book...etc) in radio 1(wlan 0) with Monitor mode
I'm not a pro/expert OpenWRT user, but I've been using OpenWRT for a long time (7 years more or less) and I also know Cisco AP's + Cisco Controllers (Mobility Express...), the short answer will be, there is nothing similar to Cisco Controllers info page in OpenWRT (as far as I know).
Hi , @Klingon
I understand your mention , so I would like to know/learn have any method/package to arrive my purpose.
Event I plug in Netgear A6210 and config it as Monitor mode
Only have one Local Interface in Channel Analysis page of Status tab
@ThiloteE ,thanks for your support.
I already install your mention packages and configure it.
Sorry for ask one question:
Do u help me check your Wi-Fi mode within your phy1-ap0 and phy1-sta0
Go to Network > Wilreless >Edit button of your phy1-ap0 and phy1-sta0 > General Setup > Mode
I personally run my device in Wi-Fi extender / repeater / bridge configuration mode via relayd. I do not run them in monitor mode. I have one "client" mode connection towards my main router and multiple "Master" wifi connections in "accesspoint" mode.