GL-MT300N-V2 - Wifi to LAN Bridge

Hi everybody, since a few days I am fighting with a GL-MT300N-V2 minrouter to setup a wifi to lan bridge. Some years I had a Netgear WNCE2001 in operation, but this is damaged. I have to replace ist with an alternative, small dimensioned solution. The plan is to have a client connected via LAN with the bridge. The bridge makes the connection to the wifi. The client needs to be part of the same subnet as other clients in the wifi/subnet.

I tried to setup the device by using the following manual: https://openwrt.org/docs/guide-user/network/wifi/relay_configuration. The point where I struggle is that the client does not get a IP via dhcp from the subnet. When I setup a static ip for the client it works.

Below you find a diagram of the intended setup.

Has someone an idea where the issue could be located?

Stephan

you might need relayd.

relayd was used.