I found your Builds for the AX1800. Did you also succeed with the AXT1800?
And would it be possible to boot from microSD when patching the bootloader (uboot)?
Thanks.
The AX1800 and AXT1800 have builds however both have a CPU locked at 1Ghz instead of 1.2Ghz.
But as @slh states its one step closer to officially being supported after all the qualcommax now has a new subtarget ipq6018 in the master branch.
2 Likes
I now have managed to hackly get the CPU to 1.2Ghz and restore the performance of crypto and now its fully booting with Kernel 6.1.78.
Check snapshot folder later on 1-2 hours from this message should be a nice surprise for you all.
4 Likes
New images are online in the snapshot folder for both the AX1800/AXT1800 Kernel 6.1.78 based.
If people can do so testing on the wireless etc to make sure its stable would be grateful.
1 Like
the r25257 broke my eth4 (AX1800), i've tried clean install but still doesn't work, in luci it shows the connection but my device doesn't get DHCP.
oh and btw using r24920 and r25257 it broke my wireguard interface after a reboot, it shows like the pic and restarting interface not solving the problem too
Thanks for the report will check mine in a bit I don't see why it broke port 4. Will look into that.
WG might require you to install WG again as currently on 25257 i have a mini install right now.
the WG problem is happening after a reboot, not after an upgrade.
I’ve setup the wg and it running great, but when i do reboot, it broke, and i had to delete and create new interface so it could run again
1 Like
Will have a look at that too as well
It's seems like on AXT1800 cooling_device number is 1 instead of 0, no? At least this is what I see right now with r24920 snapshot.
Yes, it is adjusted to 1 in the latest driver.
Will have to adjust the script at sometime been busy, I need you assistance @shi05275 since the master now has an ip60xx target in there was a patch which now expects (psgmii) however on Flint ports 4/5 seem to be busted, in terms of having a cable in ether on boot will result in a full on crash of the ssdk driver. Also they don't communicate at all packet wise. They detect cable but unable to ping.
I have tried placing all SMGII's top PCSGMII's to no avail so stuck.
Hi buddy, I sent you an email, please help to test the new GL-AX1800 firmware.
1 Like
Got your email now and will quickly flash it.
@shi05275 Flashed and tested the firmware sent to me, it works i can ping the client from the router and also ping the router via the client.
Plugging ethernet from Lan 4 to Lan 3 i get
__adpt_hppe_uniphy_psgmii_mode_set[1156]:INFO:uniphy 0 psgmii channel selection
And not the error i was getting before hand where it was saying about off
Slate AX compared to stock, I'm getting 700Mbit Wi-Fi on this firmware vs 500Mbit stock.
When using WDS, stock had an issue where multicast would stop working after a week, this one doesnt. 
Had to set cooling_device1 to fix the fan.
2 Likes
Wifi throughput or routing ?
1 Like
Wi-Fi 6 5GHz.
2.4GHz is around the same at 200Mbps.
Using Intel AX200 and iperf3 with 4 parallel.
2 Likes
1 Like
We are close then!
That's amazing, I am waiting for the official support to flash it.
i would think you could build an image from his tree to test at least....
1 Like