Gigabit Ethernet HUB HAT install?


Do anyone know how to install the second NIC from the gigabit ethernet hub hat ?

USB 3.2 Gen1 And Gigabit Ethernet HUB HAT for Raspberry Pi, 3x USB, 1x Gigabit ETH, Driver-Free
Item# 20472

From site:


I didn't find it searching the Package Table - nor searching r8152.

That's the same chip as your Belkin adapter in the other thread, so again use kmod-usb-net-rtl8152.

Note that the supplied USB jumper must be plugged in to bring the USB bus from the Pi to the HAT, using the USB connector nearest the Ethernet port. The 40 pin plug does not carry any USB signals.

1 Like