FM350-GL T-Mobile (US) No CLAT/XLAT/IPv4 address provided

[AndrewZ]

@cr08

As far as running ADB, that's where I'm currently running into an issue as it is showing it as being offline and unable to be interacted with.

Is your adb interface occupied by a serial driver by chance? See in the main thread:

Fibocom FM350-GL Support

Thank you for the information. I suggest using option driver, echo "0e8d 7127 ff" > /sys/bus/usb-serial/drivers/option1/new_id Your AT command port should be If#= 6, in the absence of other tty's it will be mapped to ttyUSB4, but with properly patched driver it should be ttyUSB3, as currently you have your ADB interface (If#= 5) occupied by the serial driver as well. Typically in such setup the gateway IP is not needed, as well as the correct netmask. You can use a device like wwan0 as your …