Firmware Selector Build Stuck at “Received build request”

Installing and Using OpenWrt
1

Hi,

I’m trying to use the “Customize installed packages” option on the OpenWrt Firmware Selector to build a minimal image for my device. However, after submitting the package list, the status stays on “Received build request” and doesn’t progress.

Here’s the list of packages I’m trying to include:

base-files ca-bundle dnsmasq-full dropbear firewall4 fstools kmod-gpio-button-hotplug kmod-leds-gpio kmod-mt7603 kmod-nft-offload libc libgcc libustream-mbedtls logd mtd netifd nftables odhcp6c odhcpd-ipv6only opkg ppp ppp-mod-pppoe swconfig uci uclient-fetch urandom-seed urngd wpad-basic-mbedtls kmod-mt76x0e luci

Device: TP-Link Archer MR200 v5

Version: OpenWrt 24.10.1

Is this a known issue, or am I doing something wrong?

1 Like
2

I've been experiencing the same problem for the last 24 hours building on rpi4 and rpi5, 24.10.0 and 24.10.1.

1 Like
3

Known issue, currently. It is discussed in these two threads:

I'll close this thread since it's already covered elsewhere.