Hi, I just installed openwrt-19.07.2-sunxi-cortexa7-sun7i-a20-lamobo-r1-squashfs-sdcard.img.gz from https://openwrt.org/toh/hwdata/lamobo/lamobo_bananapi_r1 https://openwrt.org/toh/lamobo/bananapi_r1 and it works pretty well. Thanks for that really good work. :slight_smile: But one question rem…

I managed to resize the overlay. The tricky (nasty) part is that there's two filesystems in the second partition. There's a squashfs and right after the squashfs a hidden f2fs. A loopmount with an offset is needed. One needs to install losetup and use it to display the offset on the running system,…

[image] hadmut1: but that does not work with this image, since the second partition is a squashfs. The sauashfs partition is read-only and normally you will have a writeable jffs or ext4 partition as writeable overlay. This one should be resizeable with the common tools.

I have the same question. Which partition should i resize?

Sorry, but that reply is useless. "Should" doesn't help. I see a vfat on partition 1 and a squashfs on partition 2. In the running system I see /dev/root mounted as squashfs on /rom, while on the other hand, /dev/loop0 mounted as f2fs on /overlay where /dev/loop0 is allegedly set to the 'file' /…

I just encounter the same problem when installing squashfs images on raspberry pi sdcard, can you explain the detail on how to expand the partition? thank you.

I follow the instructions here with some modification. Install required PKGs opkg update && opkg install block-mount kmod-fs-ext4 kmod-usb-storage kmod-usb-ohci kmod-usb-uhci e2fsprogs fdisk Create new partition, /dev/mmcblk0p3, and reboot root@Rpi3:~# fdisk /dev/mmcblk0 Welcome to fdisk (uti…

Hello hc62, A very big thank you for your great and super helpful tip! May I point out a small typo? When specifying the start sector 5811632 you are wasting about 2.5 GB of the SD card because there is a gap of 5,230,000 sectors ... That's just a minor thing, no question about it! I just wante…

[image] Expanding OpenWrt squashfs image? (SDcard) Installing and Using OpenWrt I follow the instructions here with some modification. Install required PKGs opkg update && opkg install block-mount kmod-fs-ext4 kmod-usb-storage kmod-usb-ohci kmod-usb-uhci e2fsprogs fdisk…

Using this commands is Linux routine - to those who know how - but how it goes to access a console in the firmware? I tried to add the 2nd avail overlay but its gone after a reboot. And that internal storage (WG 3526 16M) is very tiny. How much storage in total can such firmware handle? tempfs …

I found this bug related to the problem: [image] FS#2231 : fstools: PREINIT calling of block extroot doesn't acknowledge...

Expanding OpenWrt squashfs image? (SDcard)

Installing and Using OpenWrt

pierrehavelaar October 5, 2020, 7:15pm 11

I found this bug related to the problem:

Raspberry Pi 4 B extroot configuration