EAP225 permament reset to factory settings

Hardware Questions and Recommendations
1

Hardware Version: V3

Hello

My EAP225 seems to be failured. From Sunday yellow led has started to blink. I have reseted device. Then after adopting to OMADA controller after a few minutes it resets again, brings back factory settings and try to pending and I Have to adopt it again and again.

I have changed firmware and it does not help. Then I have changed power source and situation is still the same. After adopting it resets after few minutes and needs to be adopted again.

It looks like some electronics problems. Maybe there is some capacitor failure that has to be replaced?

2

is this an issue related to openwrt ?

1 Like
3

You appear to be running the vendor firmware on your device -- otherwise you wouldn't be able to adopt it to the Omada controller.

As such, you're clearly not running OpenWrt. That means this is off-topic in the OpenWrt forums.

Please reach out to TP-Link for help with your issue. Or, if you are actually using OpenWrt, please feel free to clarify.

1 Like
4

This topic was automatically closed after 2 hours. New replies are no longer allowed.