Dynalink WRX36 - sporadic wireless clients ping issue

So the clean 23.05.0-rc2 build containing the newer WiFi drivers WLAN.HK.2.9.0.1-01837 still had the 'no reply ping' issue (i.e. no reply to pinging WiFi devices within the same br-lan).


Swapped to the older WiFi drivers WLAN.HK.2.9.0.1-01385 and kept adding to my config, testing in between, so far so good.

During the addition of 2x guest WiFi (the last config required to complete my setup), I enabled the setting Isolate Clients for each, saved.

Immediately experienced the 'no ping reply' issue on the 2x default non-guest WiFi's.

I unchecked both Isolate Clients settings, then re-enabled them, now a working configuration! :dizzy_face: :face_with_open_eyes_and_hand_over_mouth:

So this solved this issue:
1/ using older WiFi drivers WLAN.HK.2.9.0.1-01385 and
2/ the WiFi guest isolate setting requires to be done twice

It's been running OK for just over 1 day now, will post if the same issues reoccur. :pray:

edit using the 01837 drivers again, the issue appeared immediately

2 Likes