Dumb AP Guide needs to be updated and OPKG not working

[Vince-PH]

Hi!

Apparently it doesn't listen to all. Co'z when I added 192.168.1.2 in the uhttpd config it became accessible. Though I know that the 0.0.0.0 is supposed to signify that is should listen to all addresses.

The only thing not working is https and found in the guide in cert regeneration that it needs IP address.

I have read the Dumb AP guide. I know that you need to do stuff related DNS and DHCP.

Don't get me wrong, I mean I may have misunderstood the guide but definitely I have read it.

I actually decided to make a case here in the forum since there are more than a couple of unresolved cases with similar problem like this:

Can't access OpenWrt web gui LUCI

Thank you! I did several hard resets and got it setup now the way it used to (sort of) and i do notice that not every interface that is setup can be accessed through the GUI. I have setup VLAN 1 on the WAN port (eth0) to connect to the edge router (because i need all 4 LAN ports) with IP 192.168.1.150 again. This i can´t access through the GUI. I have also setup a bridge for the wireless and VLAN 1 and this does provide access to the GUI. Still not sure what i am doing wrong here but at least…